How do I drain water from my Samsung Heat Pump Tumble dryer without using the water tank?
Your Heat Pump Tumble dryer comes with a built-in water tank to drain water. However, if you do not want to use the water tank, you can install a drain hose instead. A long drain hose is provided and can be used as an extension to the main drain hose.
1
Locate the drain hose on the rear of your washing machine.
![The drain hose is located on the rear side of the tumble dryer]()
2
Remove the drain hose from hole (A) and insert it into hole (B).
![Remove the drain hose and insert it into the hole on the right hand side]()
3
Insert one end of the accessory hose (long drain hose) into hole (A).
![Attach the accessory hose to the hole on the left hand side]()
4
Insert the other end (outlet) of the accessory hose to the drainage system in one of the following ways:
Over a wash basin
1
Make sure to place the end of the accessory hose lower than 90 cm from the bottom of dryer.
2
To bend some point of the accessory hose, use the supplied plastic hose guide (B) and secure the guide to the wall with a hook or to the tap with a piece of string. Assemble the drain hose (A) and the hose guide (B) and fix them with the cable-tie (C).
3
You can drain the condensed water by connecting the accessory hose (long drain hose) to the drain-outlet directly.
![Connect the accessory hose to your sink's drain outlet directly]()
Please note: Do not extend the drain hose as water may leak from the connected area. Instead, use a long drain hose.
Using the drain pipe of the wash basin
1
Assemble the hose connector (A) and attach it to the end of the accessory hose as shown.
![Attach the hose connector to the end of the accessory hose]()
Please note: To prevent water leak, make sure to connect the hose and the connector firmly.
2
Connect the hose adaptor directly to the drain pipe of the wash basin.
![Connect the hose adaptor to the wash basin drain pipe]()
Thank you for your feedback!
Please answer all questions.